L3 Car HUD OBD 2 II Head Up Display with Speedometer Oil Temperature Gauge Overspeed Water Temperature Alarm Clear Fault Code
Feature:
1. Reflective imaging, no film and no ghosting. The display is very clear during the day.
2. The speed can be switched to kilometers KM and miles MPH.
3. Beautiful design.
4. New functions: oil temperature, intake pressure (psi).
5. When the speed is switched to MPH, the water temperature will automatically switch to Fahrenheit℉, the single driving distance will automatically switch to Miles, and the fuel consumption will automatically switch to Gallon MPG.
6. Function: speed, rotation speed, water temperature, voltage, fuel consumption, clock, single travel distance, single travel time, oil temperature, intake pressure (psi), single and 4-stage overspeed alarm, engine failure alarm, fault code elimination, Water temperature alarm, speed alarm, gear shift reminder, voltage alarm, mile switch, fatigue driving reminder, automatic and manual brightness adjustment. The display mode can be switched freely, supports hybrid vehicles, and automatically starts and stops
Specification:
Ambient temperature: -40~+80 °C
Air pressure: 86-106 kPa
Relative humidity: 10% -95%
Environmental noise: <= 60dB (A)
Alarm sound level: <=30dB (A)
Working voltage: 11V~18V DC (12V DC/200mA)
Sleep current: <=30mA
Product size: 135X67X30 mm (folded), 135x68x56mm (unfolded)
Display channel: LED display
Reflector transmittance: 96%
Virtual image distance: 55 mm
Left and right viewing angle: 60°
Downward viewing angle: 15°
Applicable models: cars with OBD2 interface
Troubleshooting:
1. No display on the screen, no power
Start the car engine; check whether the OBD cable is tight; pull down the OBD cable several times to confirm; check whether the HUD power switch is turned on. If there is still no display, please change the car to test and analyze whether the on-board OBD diagnostic interface is good. If it is not good, please repair it and try again.
2. When the HUD is turned on, the HUD only displays the vehicle voltage, and it will automatically turn off after 30 seconds of driving.
HUD is only applicable to cars under OBD2 agreement and EU-OBD agreement (European area: after 2003, other areas: after 2007);
JOBD and OBDI are not supported. It is recommended to test on another vehicle.
3. Inaccurate speed
a. First check whether the speed unit is correct. The speed unit can be switched to KM/H and MPH. Short press the wave key to switch between KM/H and MPH.
b. When the HUD is turned on, press and hold the setting button vertically for 5 seconds to enter the menu option, and find Speed Adjustment. The upper and lower setting buttons increase or decrease the value according to the difference until the display is correct. Adjust, press vertically to save within 5 seconds.
4. Wrong operation leads to crash. Or the data is inaccurate to reset the settings.
Note:
There may be slight size deviations due to manual measurement, different measuring methods and tools.
The picture may not reflect the actual color of the item because of different photographing light, angle and display monitor.
Packing list
1X HUD
1X OBD cable (16 pin)
LX anti skid pad
1 x instruction
No related record found